A few months ago we inquired our audience, family, friends and connected people about their knowledge and interest in relation to 3D printing. The number of participants amounted to 69. We realize that it did not reach many people thus the sample might not be very representative. Yet, it isRead More →

Specifications Minmi opentronix.com  Printing volume 130 × 170 × 110 mm³  Heated bed? Yes  Filament size ∅ 1.75 mm  Open filament? Yes. Layer resolution 400 um up to 15 um Travel speed up to 120 mm/s   Host/Slicer Software: Cura, Slic3r, Pronterface, Matter Control…  OS Linux, Windows, Mac  Firmware MarlinRead More →

Specifications Balaur opentronix.com  Printing volume 170 × 130 × 110 mm³  Heated bed? Yes  Filament size ∅ 1.75 mm  Open filament? Yes. Layer resolution 400 um up to 15 um Travel speed up to 120 mm/s   Host/Slicer Software: Cura, Slic3r, Pronterface, Matter Control…  OS Linux, Windows, Mac  Firmware MarlinRead More →

Introduction Little Home lamps define what a companion light is. It is present, it’s gentle, and it’s in tune with you. Try it! You can take it with you wherever you go. It is pocket-sized and battery powered allowing you to move it with ease from one place to another.Read More →

It is now time to wire the ILI9325. You can find more information about the ILI9325 by reading the datasheet controller/driver chip. The imx233-Olinuxino-Micro pinout can be found in the user’s manual, chapter 6. Page 32 also provides a reference to a pinout summary made by David Whittaker, which is quiteRead More →

Interfacing the DS1077 oscillator module The DS1077 Package This IC comes in a SOIC package, therefore Sparkfun did a nice breakout board for it. In this project we used the breakout board, but if we were using the bare chip everything should work the same way as described here. ThisRead More →