A few months ago we inquired our audience, family, friends and connected people about their knowledge and interest in relation to 3D printing. The number of participants amounted to 69. We realize that it did not reach many people thus the sample might not be very representative. Yet, it isRead More →
Specifications Minmi opentronix.com Printing volume 130 × 170 × 110 mm³ Heated bed? Yes Filament size ∅ 1.75 mm Open filament? Yes. Layer resolution 400 um up to 15 um Travel speed up to 120 mm/s Host/Slicer Software: Cura, Slic3r, Pronterface, Matter Control… OS Linux, Windows, Mac Firmware MarlinRead More →
Specifications Balaur opentronix.com Printing volume 170 × 130 × 110 mm³ Heated bed? Yes Filament size ∅ 1.75 mm Open filament? Yes. Layer resolution 400 um up to 15 um Travel speed up to 120 mm/s Host/Slicer Software: Cura, Slic3r, Pronterface, Matter Control… OS Linux, Windows, Mac Firmware MarlinRead More →
Introduction Little Home lamps define what a companion light is. It is present, it’s gentle, and it’s in tune with you. Try it! You can take it with you wherever you go. It is pocket-sized and battery powered allowing you to move it with ease from one place to another.Read More →
It is now time to wire the ILI9325. You can find more information about the ILI9325 by reading the datasheet controller/driver chip. The imx233-Olinuxino-Micro pinout can be found in the user’s manual, chapter 6. Page 32 also provides a reference to a pinout summary made by David Whittaker, which is quiteRead More →
Now that you’ve recharged your batteries let’s proceed and connect our display. Let’s start by wiring the ST7735. You can read more information about the ST7735 in the datasheet controller/driver chip. As you can see in the picture this LCD uses Serial Peripheral Interface bus (SPI): MISO, SCLK, MOSI andRead More →
We had our imx233-Olinuxino-Micro in its box for too long but we finally managed to run some electrons through it 🙂 We needed to have our wifi USB module – Realtek RTl8192cu Chipset working. Also, we wanted to connect our TFT LCD displays : the 1.8″ Color TFT LCD displayRead More →
Interfacing the DS1077 oscillator module The DS1077 Package This IC comes in a SOIC package, therefore Sparkfun did a nice breakout board for it. In this project we used the breakout board, but if we were using the bare chip everything should work the same way as described here. ThisRead More →